Still, it's a shame, since virtually all of the available third party RTX 407… RyanSmithAT: That much is definitely true.RyanSmithAT: SK hynix didn't go into this in their press release, but their 12-Hi HBM3 stacks are using a new fill material call….There's a post penned by SK hynix at EETimes which… RyanSmithAT: Yeah, liquid EMC was not the most detailed disclosure.gavbon86: There's nothing worse than cleaning a child's sick up off of everything! The stuff gets everywhere like an explosion.gavbon86: Some users have had issues with AM5 boards when using AMD's Ryzen 7000X3D series processors (Zen 4 with 3D V-Cache)….gavbon86: Huge congratulations gavbon86: Also a good piece of analysis/thoughts via about the possible damage of the affected CPU/bo….It’s an incredibly useful diagnostic tool that’s honestly a step beyond what Tomato or even DD-WRT report for clients. The utility will show each client MAC address, signal, noise level, rate, and what network mode they’re using. One of the features Airport Utility has that a lot of other consumer devices don’t is a nice way of viewing the status of attached wireless clients, including a little graph that continually tracks. I’ve experimented around and even a USB hub plugged in with devices attached to it works, so you’re not limited to just a single port. In addition to sharing disks, the Airports can also share printers attached using USB. That said, some of the options are a bit barebones compared to more enthusiast open source packages, but it gets the job done. If you run the devices as a router, you can also port forward, configure the DHCP server (including static addresses assigned to specific MACs), and all the usual fixings. There’s honestly everything you’d want from a consumer level router or wireless AP, and a couple of extras like RADIUS server support and guest network creation. As an aside, if you’re going to set the 5GHz channel manually, select one over 149 to get maximum power and avoid dynamic frequency selection chanels in the US. Each of the radios (2.4 and 5GHz) can be set to its own SSID, there are a wide selection of radio modes and the ability to set channels manually. The rest of configuration is honestly pretty straightforward. The utility can also monitor for when problems happen. Status mirrors the front panel LED which either glows green or amber depending on whether things are working fine.įor example, when the Time Capsule starts overheating the LED blinks amber and pops up an alert. The first page is summary, which lists some basic information, status, and high level information. There’s either the choice to have a wizard set everything up, or you can do it manually. Admittedly that’s a nice touch that makes configuration super easy. It pops up a list of devices, including unconfigured ones without the need to connect over ethernet. On all of Apple’s WiFi products, Airport Utility is the exclusive point of configuration. There’s no web-based portal like just about every other attached network device. To start, all configuration is done through Airport Utility on OS X and Windows. I’m not going to go into very much detail at all about the network side of things (routing performance, etc.) since honestly nothing has changed here-the board and SoC are the exact same. The only remaining thing to go over is the Airport Utility and general network functionality.
0 Comments
Leave a Reply. |